Sparkular FX Set 3

Description

Do you want to create a dazzling effect during your event? Then you can use firework fountains. This often requires a fireworks permit. With this Sparkular FX set 3, you don’t need one! The Sparkular provides a beautiful effect based on cold fire, so you don’t need a fireworks permit. Ideal for any type of event where you want to create a wow effect.

What does the Sparkular FX Firework Fountain Set 3 consist of?

The set consists of six Showven Sparkulars to use on either side of the stage. Additionally, this firework fountain set includes the necessary cabling and control system for the Sparkulars. Furthermore, this set is also provided with the required powder for the devices. This amount of powder is enough for about 10 minutes of cold sparks. Do you need more powder to create a firework effect for longer than 10 minutes? Then please contact us.

How high does the firework fountain effect reach?

The Sparkular FX firework fountain set 3 is capable of creating a fire fountain up to a certain height. For a beautiful wow effect, this set can reach a height of 5 meters. The height of the effect can be determined with the controller. This gives you a range of 2 to 5 meters.

Is the Sparkular FX Set 3 safe to use?

Because the Sparkular creates sparks of cold fire, this set is safe to use. Both indoor and outdoor use is no problem. Despite the fact that the effect consists of cold fire, we recommend maintaining a small safety margin of 1 meter around the Sparkular. Additionally, it is advisable not to let the sparks hit a ceiling or other overhead covering for prolonged periods.

How do I use the spark fountain set?

The Sparkular FX firework fountain set 3 is easy to use. With the included controller, you can easily operate the fire fountains. As mentioned earlier, each Sparkular comes with powder for about 10 minutes of effect. Of course, you don’t have to use these 10 minutes all at once. By operating the Sparkulars with the controller, you determine how long and how often the effect is shown. This allows you to spread the 10 minutes over the duration of your event.

Do you need more powder to create a firework effect for longer than 10 minutes? Then please contact us. Keep in mind that the devices need about 10 minutes to warm up. Therefore, turn them on in advance.

How do I connect the Sparkular FX firework fountain set 3?

1. Start by placing the Sparkulars on a sturdy, safe surface. Connect them to the mains with the blue PowerCON cables and turn the connector to the right until you hear a click. Place the controller in a spot where you have a good view of the fountains and connect it to the power supply.

2. Connect the DMX cables to control the Sparkulars. The controller is connected to the first fountain via a long DMX cable: the plug with pins goes into the DMX output of the controller, the other end (with the three holes) goes into the fountain. Then the signal can be looped through to the next fountain. Continue looping until all six Sparkulars are provided with a DMX cable.

3. Fill the fountains by opening the lid on top and pouring the special powder into the reservoir using the funnel. Be careful not to get the powder into the white circle.

4. To warm up the fountains, slide the second slider on the DMX controller all the way up. Warming up takes about 10 minutes. Make sure to do this well before the show and leave the slider up as long as the Sparkulars are in use.

5. Activate the fountain by moving the first slider up. The height of the sparks depends on how far you open the slider. To prevent overheating, the fountain should not operate continuously for more than 30 seconds.